Alu Honeycomb marble composite Lightweight Stone Panels For
exterior wall system
Aluminum honeycomb panel is a lightweight strong sandwich composite
laminated panel, the weight of aluminum honeycomb panel is only 3kg
to 10kg per square meter for panel thickness of 6mm to 300mm and
the regidity is more than 1.5kN.sqm/m , with prefabrication and
assembly of fittings according to framing system, you can easy
install the honeycomb panels to the buildings, also very popular
for envelope and decoration of interior & exterior walls,
partitions, facades, ceiling and canopies. Aluminum honeycomb panel
or stainless steel honeycomb sandwich panel is the best alternative
materials for single aluminum panel or stainless steel panel
because of the competitive cost and much lower weight, much better
flatness and much higher strength. It's a green and
environment-friendly building and decoration material, trending the
construction and decoration industry.
|Feature:||Environmental ,no radiation, no pollution ,no harm to body,low
water absorption,high waterproof|
|Color:||Red,blue,green,black,grey,yellow,mix color ect.|
|Size:||2440*1220mm,1800*900mm 300*300mm,600*600mm,800*800mm,or Custom size|
|Backing:||Mesh, Ceramic, Porcelain, Marble, Glass, Artificial Stone, Granite
|Surface Finished:||Polished, Honed with resin glue|
|Usage:||Countertops, kitchen tops, bathroom vanity top,worktops,
laundry,table tops,bench top, island tops, bar tops, backsplashes.
Tub surrounds ,all tile, wall cladding, floor tile for Commercial
& Hospitality & Multifamily project.|
|Quality Control:||Polished degree:90 degree or up.As customs' requirement|
|All products checked by experienced QC and then pack|
|Packing:||Inner package: protect film, foam and pallet|
Outer package: carton/wooden case
• Low weight and competitive cost
• High stiffness and strength
• Easy to fabricate and install
• PVDF coating or anodized finish aluminum facing skins for good
anti-corrosion performance and high resistance.
• Aluminium facing skins are available in a range of thicknesses
from 0.5mm to 3.0mm as per design requirements
• Panels can be produced with different aluminum sheet thicknesses
on front and back faces and panel thicknesses as per custom design
requirements for weight, strength and installation.
• Aluminum faced panels are chemically cleaned: suitable for
painting or the application of decorative laminates
• Brushed and anodised aluminum finishes are also available
• Aluminum honeycomb cell size is 4mm to 8mm as request.
• Wide selection of Joiners &Assembly Accessories are
Q1: Will the thin stone panels easily broken?
A1: No, our thin stone panels are even stronger than solid 2cm full
Q2: Is this type of thin stone panels delaminate under hot and cold
A2: No, we have done projects in Saudi and Norway for more than 10
years, everything is OK till now.
Q3: How to cut thin stone panels?
A3: It is same as full 20mm thick stone, can be cut easily.
Q4: How many types of finished can be done on thin stone panels?
A4: Polished, Honed, Sandblasted, Flamed, etc
Q5: Will the thin panels bending?
A5: Yes, it will be bending under hot or cold weather, but it will
be always straight after installed.